[Rovernet] Replacing the finishing trim around the doors of a P-6
Vern Klukas
vern at inkspotco.com
Fri Sep 20 17:46:04 EDT 2013
Jim
Are you aware that the P6 uses three different sized of Furflex? Perhaps you only got the small size. Now I can't recall if the U clip part was a different size, or if it was just the half round of foam on top.
Making you own is quite easy, the tricky bit is finding a material to match the fur. I couldn't find a good match when I tried many years ago and ended up using a velvet, which wore away in just a few months. But then again, I only went to one fabric store, it was long before I got picky about the authenticity of things.
Yours
Vern
On 2013-09-20, at 5:57 AM, peter prosser <peterprosser at yahoo.com> wrote:
> make your own and save $$$
>
>
> ________________________________
> From: James Pile <jpile1 at verizon.net>
> To: Rovernet <rovernet at rovernet.org>
> Sent: Friday, September 20, 2013 7:38:07 AM
> Subject: Re: [Rovernet] Replacing the finishing trim around the doors of a P-6
>
>
> No, Ben,
> I'm referring to the U-shaped fabric that fits around the door sills, the fabric that becomes very frayed over time.Peter King gave me the name of a supplier - Fryer's Custom Upholstery - so I'll look there for now.
> Thanks for responding, and take care. One of these days I'll have to come by for a visit. Fall is a beautiful time of year to drive a Rover in VA.
>
> JIm
>
Inkspot Type & Design 250 864 5619 in at inkspotco.com
More information about the Rovernet
mailing list