[Rovernet] P5 problem persists
magnet at ican.net
magnet at ican.net
Mon May 25 14:04:25 EDT 2015
Hi Peter,
At the risk of overloading you with suggestions...
Have you tried swapping the coil? Many (very many) years ago I had a
similar problem on my P4 and the coil was the culprit. I forget whether
the problem was shorted turns in the primary or secondary, but a new
coil exorcised the gremlin.
Speaking of coils, make certain any replacement really is a 12 volt
coil, unless your car has a ballast resistor for an 8 volt coil. Most
coils available off the shelf these days seem to assume the presence of
such a resistor, and will heat up and eventually burn out if used on a
12 volt system without one.
Good luck!
-- Bill D.
========================================On May 25, 2015, at 9:30 AM,
garrett bourque via Rovernet <rovernet at rovernet.org> wrote:
>>>
>>> Hello Peter,
>>> Another suggestion is to take the electronic ignition system off,
>>> reinstall the points and condenser. Electronic systems can overheat
>>> and
>>> stop working...until they cool off again.
>>> Good luck, Garrett Bourque
>>>
More information about the Rovernet
mailing list