[Rovernet] Where's the heat in my 3500S?

[Geoff McCarthy]

I tested my valve off car by simply applying vacuum.  You can also do the
same with it installed.

Geoffrey W. McCarthy MD MBA DipAvMed
677 NW Melinda Ave
Portland OR 97210
503-241-8468 (h)
503-799-3809 (m)

-----Original Message-----
From: Rovernet [mailto:rovernet-bounces at rovernet.org] On Behalf Of Jim Pile
via Rovernet
Sent: Sunday, November 20, 2016 2:02 PM
To: Rovernet <rovernet at rovernet.org>
Cc: Jim Pile <jpile1 at verizon.net>
Subject: [Rovernet] Where's the heat in my 3500S?

AC works fine, but it's the time of year when I need Heat!

	Didn't work last year so I replaced the vacuum valve with a good (?)
used one. At least the Rover owner who sold it to me thought it was good.
Didn't fix the problem. Recently, I took out the heat control switch (behind
the console) to make sure all the lines were connected: They were, though
some fit a  little loose. The letters on the vacuum hoses match up to the
diagram in the shop manual, as well.

	Any ideas what I should do next? Is there any way to run a test on
the vacuum valve to see if it's working?

	All suggestions welcome, since winter's knockin' on my Virginia
door!

		Jim Pile
_______________________________________________
Rovernet mailing list
Rovernet at rovernet.org
http://rovernet.org/mailman/listinfo/rovernet_rovernet.org