[Rovernet] stop valve and spring needed for 3500S servo

[Ben Saunders]

Hi Jim,

Ben Saunders here and I might be able to help you out but I first need 
to know what is the spring you refer to as the stop valve spring. Is the 
one that goes in the vacuum switch to operate the vacuum?


On 07/31/2019 09:14 PM, Jim Pile via Rovernet wrote:
> Hello, my friends,   Rebuilding the servo and I can't go any further without the stop valve/spring that somehow went missing when the previous owner did an overhaul.Perhaps someone has an extra servo lying around that would not miss the valve. I do have an extra servo kit for the 3500 to barter with, or - of course - $$. If none is available, could this little piece be cross-referenced to a similar servo? Probably not likely. That little piece is the only thing keeping the car off the road!
> I look forward to your thoughts and suggestions.
>              Jim Pile
> -------------- next part --------------
> An HTML attachment was scrubbed...
> URL: <http://rovernet.org/pipermail/rovernet_rovernet.org/attachments/20190801/0a278b6a/attachment.html>
> _______________________________________________
> Rovernet mailing list
> Rovernet at rovernet.org
> http://rovernet.org/mailman/listinfo/rovernet_rovernet.org