[Rovernet] 2000TC Flywheel - Clutch burned out

[Vern Inkspot]

Hi Bob

The flywheel face isn't recessed, so how much it has been surfaced should not matter to the pressure plate. At some point you might have a problem with not enough travel for the release bearing to disengage the clutch, but I can’t see how you’d get a slipping clutch.

That said, what's the engine number? If it starts with 400, 415 or 416 I’ve got a flywheel here in BC.

Yours
Vern

> On Aug 20, 2025, at 12:33 PM, Robert Ruggeri via Rovernet <rovernet at rovernet.org> wrote:
> 
>  
> Hi All:
>  
> Clutch on 71 Series II Federal 2000TC P6 is burned up.   Mechanic says that the clearance on the pressure plate is too big, but is not sure which part is responsible.
>  
> Problem might also be that the flywheel was turned too much during an earlier repair.   Can source a new one at Win’s, but we need one where the beveled teeth on the ring gear are facing the engine.  Win’s is facing the other way.
>  
> Anyone have the right flywheel or any advice?
>  
> Bob
> _______________________________________________
> Rovernet mailing list
> Rovernet at rovernet.org <mailto:Rovernet at rovernet.org>
> http://rovernet.org/mailman/listinfo/rovernet_rovernet.org


inkspotco.com · 250 864 5619 · in at inkspotco.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://rovernet.org/pipermail/rovernet_rovernet.org/attachments/20250820/322632b8/attachment.htm>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: E-mail Signature logo.png
Type: image/png
Size: 22660 bytes
Desc: not available
URL: <http://rovernet.org/pipermail/rovernet_rovernet.org/attachments/20250820/322632b8/attachment.png>