<div dir="ltr">Hello Jim,<div>  I am pretty sure I have some extra rubber seals like you need.  I will check in the morning,  Good luck with your Rover!</div><div>Garrett Bourque  Jefferson, Maine</div></div><br><div class="gmail_quote"><div dir="ltr" class="gmail_attr">On Tue, Oct 19, 2021 at 8:55 PM Jim Pile via Rovernet <<a href="mailto:rovernet@rovernet.org">rovernet@rovernet.org</a>> wrote:<br></div><blockquote class="gmail_quote" style="margin:0px 0px 0px 0.8ex;border-left:1px solid rgb(204,204,204);padding-left:1ex">
<div style="color:black;font:10pt arial">In dismantling the servo, I discovered that the air inlet vacuum gasket had been torn significantly.<span></span>
<div>I've included pictures of the damaged gasket, just about torn in two.</div>

<div> </div>

<div>Is there a work-around for this? </div>

<div>Would a 2000 gasket fit? If so, I could always cut the plastic end from the hose and connect it like the 2000 servo.</div>

<div><br>
</div>

<div>All suggestions welcome!</div>

<div><br>
</div>

<div>    Jim Pile</div>
</div>
_______________________________________________<br>
Rovernet mailing list<br>
<a href="mailto:Rovernet@rovernet.org" target="_blank">Rovernet@rovernet.org</a><br>
<a href="http://rovernet.org/mailman/listinfo/rovernet_rovernet.org" rel="noreferrer" target="_blank">http://rovernet.org/mailman/listinfo/rovernet_rovernet.org</a><br>
</blockquote></div>