[Rovernet] DeDion overhaul woes

Vern Klukas vern at inkspotco.com
Wed Dec 30 13:26:02 EST 2015


Hi Lance

Don’t mess with the brass bushings, they are thin and collapse easily.

In the past, I’ve just used a sharp probe to spear the seal and pull it out leaving the retainer in place. After the seal is removed I used a bearing puller to remove the retainer, though as I recall the first one I did I warped the retainer a little bit so decided I’d never do that again.

Yours
Vern

> On Dec 30, 2015, at 10:06 AM, LANCE LA CERTE PSY D via Rovernet <rovernet at rovernet.org> wrote:
> 
> Having a bugger of a time trying to figure out how to "carefully drift" out the right side retainer and seal.  The left hand side is easily prised out and replaced.    There are brass sleeves, 1 3/4" long inside each end of the outer tube.  When the manual indicates 'careful drifing' to remove the retainer (which is about 3/4" long with a small lip, on the exterior of the outer tube) I'm not sure if I'm supposed to be carefully tapping on the inner brass sleeve to push the seal and the retainer off the end????       
> Is there anyway to carefully tap around the full circumference of that small lip to get the retainer to pop off?     
> Why can't I just prise the seal out of this right end (as with the left end)  without removing the retainer, and replace with a new seal?
> If I must drift it off by drifting/tapping on the inner brass sleeve, where in the world do I find a "soft metal" drift that long?
> 
> Any help with this would be appreciated.
> 
> Lance La Certe, Psy.D.,    1970  P6B
> Outside of a dog, a person's best friend is a book.  Inside of a dog it's too dark to read.
> 
> 
> 		 	   		  
> -------------- next part --------------
> An HTML attachment was scrubbed...
> URL: <http://rovernet.org/pipermail/rovernet_rovernet.org/attachments/20151230/e1b36d2e/attachment.html>
> _______________________________________________
> Rovernet mailing list
> Rovernet at rovernet.org
> http://rovernet.org/mailman/listinfo/rovernet_rovernet.org

   inkspotco.com · 250 864 5619 · in at inkspotco.com




-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://rovernet.org/pipermail/rovernet_rovernet.org/attachments/20151230/7dff5cae/attachment.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: E-mail Signature logo.png
Type: image/png
Size: 22660 bytes
Desc: not available
URL: <http://rovernet.org/pipermail/rovernet_rovernet.org/attachments/20151230/7dff5cae/attachment.png>


More information about the Rovernet mailing list