[Rovernet] Aligning "block" for 3L pistons

[Geoff McCarthy]

Neville wants it to install the pistons.  The bores are already ready, I
think.

Geoffrey W. McCarthy MD MBA DipAvMed
677 NW Melinda Ave
Portland OR 97210
503-241-8468 (h)
503-799-3809 (m)

-----Original Message-----
From: Rovernet [mailto:rovernet-bounces at rovernet.org] On Behalf Of Kent
Kinard via Rovernet
Sent: Wednesday, November 02, 2016 7:35 PM
To: Rovernet <rovernet at rovernet.org>
Cc: Kent Kinard <kkinard at att.net>
Subject: Re: [Rovernet] Aligning "block" for 3L pistons

Hi Goeff,
Have you consulted a machine shop?  I seem to recall that this device is no
longer required in order to machine the block.
Kent k.

Geoff McCarthy via Rovernet wrote:
> Anyone out there have this accessory, which is used to make the 
> slanted block square, and enable the pistons to be installed evenly?
Thanks !
>
>   
>
> Geoffrey W. McCarthy MD MBA DipAvMed
>
> 677 NW Melinda Ave
>
> Portland OR 97210
>
> 503-241-8468 (h)
>
> 503-799-3809 (m)
>
>   
>
> -------------- next part -------------- An HTML attachment was 
> scrubbed...
> URL: 
> <http://rovernet.org/pipermail/rovernet_rovernet.org/attachments/20161
> 102/9c5bc2fd/attachment.html> 
> _______________________________________________
> Rovernet mailing list
> Rovernet at rovernet.org
> http://rovernet.org/mailman/listinfo/rovernet_rovernet.org
>


_______________________________________________
Rovernet mailing list
Rovernet at rovernet.org
http://rovernet.org/mailman/listinfo/rovernet_rovernet.org