[Rovernet] Aligning "block" for 3L pistons

Kent Kinard kkinard at att.net
Thu Nov 3 15:42:03 EDT 2016


I understand.  I don't have a block deck plate, though.  -KK

Geoff McCarthy via Rovernet wrote:
> Neville wants it to install the pistons.  The bores are already ready, I
> think.
>
> Geoffrey W. McCarthy MD MBA DipAvMed
> 677 NW Melinda Ave
> Portland OR 97210
> 503-241-8468 (h)
> 503-799-3809 (m)
>
> -----Original Message-----
> From: Rovernet [mailto:rovernet-bounces at rovernet.org] On Behalf Of Kent
> Kinard via Rovernet
> Sent: Wednesday, November 02, 2016 7:35 PM
> To: Rovernet <rovernet at rovernet.org>
> Cc: Kent Kinard <kkinard at att.net>
> Subject: Re: [Rovernet] Aligning "block" for 3L pistons
>
> Hi Goeff,
> Have you consulted a machine shop?  I seem to recall that this device is no
> longer required in order to machine the block.
> Kent k.
>
> Geoff McCarthy via Rovernet wrote:
>> Anyone out there have this accessory, which is used to make the
>> slanted block square, and enable the pistons to be installed evenly?
> Thanks !
>>    
>>
>> Geoffrey W. McCarthy MD MBA DipAvMed
>>
>> 677 NW Melinda Ave
>>
>> Portland OR 97210
>>
>> 503-241-8468 (h)
>>
>> 503-799-3809 (m)
>>
>>    
>>
>> -------------- next part -------------- An HTML attachment was
>> scrubbed...
>> URL:
>> <http://rovernet.org/pipermail/rovernet_rovernet.org/attachments/20161
>> 102/9c5bc2fd/attachment.html>
>> _______________________________________________
>> Rovernet mailing list
>> Rovernet at rovernet.org
>> http://rovernet.org/mailman/listinfo/rovernet_rovernet.org
>>
>
> _______________________________________________
> Rovernet mailing list
> Rovernet at rovernet.org
> http://rovernet.org/mailman/listinfo/rovernet_rovernet.org
>
>
> _______________________________________________
> Rovernet mailing list
> Rovernet at rovernet.org
> http://rovernet.org/mailman/listinfo/rovernet_rovernet.org
>





More information about the Rovernet mailing list