[Rovernet] servo rod "stuck"?

[pierre janusz]

I think it is just a question of applying enough force. You can try re-attaching the large plastic piston (using the locking key) and getting better leverage with this.
Pierre


-----Original Message-----
From: Jim Pile via Rovernet <rovernet at rovernet.org>
To: rovernet <rovernet at rovernet.org>
CC: Jim Pile <jpile1 at verizon.net>
Sent: Fri, Jun 21, 2019 01:11 AM
Subject: [Rovernet] servo rod "stuck"?


In dismantling the servo in the 3500S, I came to an abrupt stop when the servo rod, which is supposed to be drawn out "gently," seems to be hindered by something: It only allows me to pull it out about 1/2 inch, then refuses to budge as if something is physically stopping it.  What am I missing?
    Thanks for any advice.
        Jim Pile
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://rovernet.org/pipermail/rovernet_rovernet.org/attachments/20190621/5fb2ff05/attachment.html>
_______________________________________________
Rovernet mailing list
Rovernet at rovernet.org
http://rovernet.org/mailman/listinfo/rovernet_rovernet.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://rovernet.org/pipermail/rovernet_rovernet.org/attachments/20190621/28825ed9/attachment.html>