[Rovernet] air inlet gasket needed for 3500s

[Jim Pile]

In dismantling the servo, I discovered that the air inlet vacuum gasket had been torn significantly.I've included pictures of the damaged gasket, just about torn in two. Is there a work-around for this? Would a 2000 gasket fit? If so, I could always cut the plastic end from the hose and connect it like the 2000 servo.
All suggestions welcome!
    Jim Pile
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://rovernet.org/pipermail/rovernet_rovernet.org/attachments/20211020/7a78b97d/attachment-0001.html>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: SERVO AIR INLET 1.jpg
Type: image/jpeg
Size: 211450 bytes
Desc: not available
URL: <http://rovernet.org/pipermail/rovernet_rovernet.org/attachments/20211020/7a78b97d/attachment-0002.jpg>
-------------- next part --------------
A non-text attachment was scrubbed...
Name: SERVO AIR INLET 2.jpg
Type: image/jpeg
Size: 184384 bytes
Desc: not available
URL: <http://rovernet.org/pipermail/rovernet_rovernet.org/attachments/20211020/7a78b97d/attachment-0003.jpg>