[Rovernet] air inlet gasket needed for 3500s

[garrett bourque]

Hello Jim,
  I am pretty sure I have some extra rubber seals like you need.  I will
check in the morning,  Good luck with your Rover!
Garrett Bourque  Jefferson, Maine

On Tue, Oct 19, 2021 at 8:55 PM Jim Pile via Rovernet <rovernet at rovernet.org>
wrote:

> In dismantling the servo, I discovered that the air inlet vacuum gasket
> had been torn significantly.
> I've included pictures of the damaged gasket, just about torn in two.
>
> Is there a work-around for this?
> Would a 2000 gasket fit? If so, I could always cut the plastic end from
> the hose and connect it like the 2000 servo.
>
> All suggestions welcome!
>
>     Jim Pile
> _______________________________________________
> Rovernet mailing list
> Rovernet at rovernet.org
> http://rovernet.org/mailman/listinfo/rovernet_rovernet.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://rovernet.org/pipermail/rovernet_rovernet.org/attachments/20211019/d5cf901d/attachment.html>