[Rovernet] air inlet gasket needed for 3500s

[pierre janusz]

Jim,
If you need these, I can supply new ones.
Pierre


-----Original Message-----
From: Jim Pile via Rovernet <rovernet at rovernet.org>
To: rovernet at rovernet.org <rovernet at rovernet.org>
CC: Jim Pile <jpile1 at verizon.net>
Sent: Wed, 20 Oct 2021 1:54
Subject: [Rovernet] air inlet gasket needed for 3500s

In dismantling the servo, I discovered that the air inlet vacuum gasket had been torn significantly.I've included pictures of the damaged gasket, just about torn in two. Is there a work-around for this? Would a 2000 gasket fit? If so, I could always cut the plastic end from the hose and connect it like the 2000 servo.
All suggestions welcome!
    Jim Pile_______________________________________________
Rovernet mailing list
Rovernet at rovernet.org
http://rovernet.org/mailman/listinfo/rovernet_rovernet.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://rovernet.org/pipermail/rovernet_rovernet.org/attachments/20211020/22d6b75c/attachment.html>