[Rovernet] Rare bits wanted (correction)
Kent Kinard
kkinard at att.net
Mon Mar 17 13:13:29 EDT 2014
5x5correction: SD1 wheels are metric, but almost 5x5. -KK
Kent Kinard wrote:
> Sorry, Tom. All Rover saloons P4 through SD1, at least use 5x5
> wheels. The Magnum 500 wheels are the only exception from the factory.
> Austin used 5x5 wheels on its largest models as well. Jensen
> Interceptor uses 5x5 wheels...early ones are P5B Rostyles. Later ones
> are aluminum and look good on both P5 and P6.
> Roverly,
> Kent K.
>
> Tom Rymes wrote:
>> On 03/16/2014 7:58 PM, louatlcf at aol.com wrote:
>>> Hi
>>>
>>>
>>> I have a 1966 Rover 2000TC equipped with Dunlop brakes and a single
>>> 7 inch servo one of the first imported and I have Rostyle wheels.
>>> See attached Pics. I didn't think there were an earlier version, if
>>> so must be rarer than my car.
>>>
>>>
>>> Lou
>>
>> Further to this, it was my understanding that the P5/P5B and the
>> P6/P6B all used the Chevy/Jaguar 5 x 4.75" bolt pattern, which should
>> allow a very large selection of wheels for the OP to choose from.
>> Unless your're bound and determined to use a BMW wheel, I would think
>> that 5 x 4.75" would meet your needs.
>>
>> Tom
>>
>> _______________________________________________
>> Rovernet mailing list
>> Rovernet at rovernet.org
>> http://rovernet.org/mailman/listinfo/rovernet_rovernet.org
>>
>
>
> _______________________________________________
> Rovernet mailing list
> Rovernet at rovernet.org
> http://rovernet.org/mailman/listinfo/rovernet_rovernet.org
>
More information about the Rovernet
mailing list